Table of Contents
Advertisement
OTHER SETTINGS
Enter country code
Certain mobile operators remove the country code from incoming texts, which can cause a problem if ControlBox24/7 has to be controlled from
a country other than where it is placed. A problem can arise sending back the confi rmation message (only applies if the STEL commando is
deactivated). If the problem does occur, you can use the following command to work around it:
NACO 0&<XXXX>
Example: NACO 0&0046
0
= The numbers to be replaced by the country code (usually a zero)
XXXX = Country code where the mobile sending the command is located.
The example above enters the country code when the command text message was sent from Sweden and the ControlBox24/7 is in another
country. i.e.: it is the mobile which sends the text message which determines which country code will be stated.
To remove the country code setting stated, send the following text message to ControlBox24/7;
NACO &
NOTE! Only state the country code if you fi nd problems with receiving the confi rmation message from ControlBox24/7.
16
Advertisement
Table of Contents
