Redirecting the confi rmation message
By default, your ControlBox24/7 will send all correctly formulated commands back to the same telephone number they came from.
If your ControlBox24/7 is used by other people, and you want to direct all confi rmations of incoming commands to the unit to a single number, you
can designate a standard telephone number as follows:
STEL <X>
Example: STEL 1
X =
0
1
2
3
Inactive TEL1 TEL2 TEL3 TEL4 TEL5
In the example above, all confi rmations will be sent to the telephone number saved at TEL1 - See "Programming - Set up reporting number".
Redirecting the confi rmation message
To check which settings your ControlBox24/7 has at any time, you can request them by entering the following:
SET?
ControlBox24/7 will return all settings made on the unit.
4
5
15
OTHER SETTINGS
Need help?
Do you have a question about the ControlBox24/7 and is the answer not in the manual?