If your ControlBox24/7 is located where the temperature is consistently a few degrees higher or lower than where you want to measure it, you can
adjust the temperature on the unit.
To compensate the monitored temperature, send the following text message to your ControlBox24/7:
0 for positive value, 1 for negative value.
0.5°C 1.0°C 1.5°C 2.0°C 2.5°C 3.0°C 3.5°C
If you want your ControlBox24/7 to show 2.5 degrees higher than the actual temperature measured, send the following text message to the unit.
Where "0" stands for "+", i.e. the temperature reported will show 2.5°C above the actual temperature where ControlBox24/7 is
If you want to adjust the temperature shown downwards 1.5°, send
TADJ 125 Where "1" stands for "-", i.e. the temperature reported will show 1.5°C below the actual temperature where ControlBox24/7 is located.
To deactivate temperature compensation, send: