Send Report - Bosch Security System Owner's Manual

SEND REPORT?

Description
This function tests the communication link between your security system and your security
company. It is an important part of maintaining a high level of security for your property.
Two types of test reports may be sent. The first type of report is a simple test report COMMAND
41. The second type of report is a status report COMMAND 42. This status report indicates the
current condition of your system.
Using Send Report:
1. Always call your security company before sending a test report.
2. Ensure your command center is at idle text.
3. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
4. Press the [4] key, then press the [1] key.
Note: If you prefer, you may use the Command Menu in place of steps 3 and 4 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the SENT REPORT ? prompt. Press [ENT].
5. TEST REPORT? displays.
• If you wish to send a test report, press [ENT].
• If you wish to send a status report, press [NEXT] to display STATUS REPORT ?. Press
[ENT].
6. The command center displays SENDING REPORT until the report is transmitted to the security
company. When the transmission is complete the command center displays REPORT SENT for
5 seconds and then returns to idle text.
7. If [ESC] is entered the display will return to idle text. If the test (or status) report doesn't
successfully transmit to the central station, the command center will display COMM FAIL after
numerous unsuccessful attempts.
41
&
42