Bosch Security System Owner's Manual page 54

6. After arming your system, leave the building through a door programmed with exit
delay time. Your command center emits an intermittent beep tone and counts down the
exit delay in the display.
• If you open a door after exit delay time expires, entry delay time begins. Turn the
system off to avoid an alarm event.
Turning On Selected Areas
You can use this Command Menu function to turn on both perimeter and interior points in some
or all of the areas where your passcode has authority. If there are areas already turned on, this
function turns on all areas that are off without changing the status of the areas that are already on.
1. Press the [ESC]/[MENU] keys to enter the Command Menu.
2. Press the [NEXT] key until the MASTER ARM ? function is displayed. Press [ENT].
3. The display shows MASTER ARM ALL ? Press [NEXT]. The display shows ARM
AREA X ?, which is the first area you have authority to arm.
4. Pressing the [NEXT] key allows you to scroll any other areas you have the authority to
arm into the display.
5. When the display shows the area you wish to arm, press [ENT].
6. Your system may require a passcode before allowing you to access this function. ENTER
PASSCODE appears in the display. Enter your passcode and press [ENT].
7. After turning on other areas, the command center's display returns to the disarmed idle
text for the area you are in. If you wish to turn on that area enter your personal passcode
and press [ENT].
Faulted Points in Other Areas
If there is a faulted point in an area you select (other than the one you are in), CHK AREA
appears for 3 seconds and then the display returns to the area disarmed idle text. Try one of the
following:
• Clear faulted points (close doors and/or windows) and return to step 1.
• Bypass faulted points (if your system and/or authority allows) and return to step 1.
• Force arm (if your system and/or authority allows). See Turning the System On With
Doors or Windows Open in the Security System User's Guide.