Bosch Security System Owner's Manual page 13

UNBYPASS A POINT?
Description
Unbypassing a point is a way to return a bypassed point to the security system so that it can once
again respond to trouble and alarm conditions.
Using Unbypass a Point:
1. Ensure your command center is at disarmed idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [0] key, then press the [0] key again.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU ]key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the UNBYPASS A POINT ? prompt. Press [ENT].
4. The display shows ENTER PT NUM.
• If you know the point number you wish to unbypass, enter the number and press
[ENT]. A description of the point type is displayed, such as POINT ## @@@@@@ (where
## = the point number and @@@@@@ = point type). Press [ENT] again.
• If you don't know the number of the point you wish to unbypass, you can view the list
of devices that can be unbypassed by pressing the [NEXT] key without entering any
digits when ENTER PT NUM is displayed. Continuously pressing [NEXT] scrolls
through these devices. When the point text of the point you wish to unbypass appears,
press [ENT].
5. One of the following messages displays:
PT ## UNBYPASSED indicates the point is unbypassed.
•
• PT NOT BYPASSED indicates that the point had not been bypassed.
• INVALID POINT indicates that the device is not assigned to the area that you are in.
• 24-HOUR-FAULTED indicates that the device is a "24-HOUR-DEVICE" and is
currently faulted, and must be returned to normal prior to unbypassing.
• FIRST DISARM indicates the area is currently armed and needs to be disarmed prior
to unbypassing the point.
• NO POINTS indicates that there are no points remaining to be unbypassed.
7. To confirm that the point is back in the system, press a number key at idle disarmed text and
view the scrolling list of currently faulted and bypassed points.
8. If the point now displays as faulted it will not completely return to the system until the door or
window is shut.
9. If the unbypassed point was the last bypassed 24-hour or fire point, the messages 24 HOUR
BYPASS or FIRE BYPASS will automatically clear.
00