Bosch Security System Owner's Manual page 18

Hide thumbs Also See for Security System:

Table of Contents

When the operator directs you, enter COMMAND 43 at your command center. Press the

[COMMAND] bar. The display shows SYSTEM COMMAND. Now press the [4 ] key, then press

the [3] key. Do not hang up the telephone.

Note:

If you prefer, you may use the Command Menu in place of steps 3 and 4 to initiate this function.

Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you

reach the REMOTE PROGRAM ? prompt. Press [ENT].

The display shows CALL RAM ? Note: The central station may direct you to press [NEXT].

When you do this, ANSWER NOW displays. Press [ENT] and the system will behave as described

in steps 5 - 8 above.

•

If you want your system to call the RAM, press [ENT] when the display shows CALL

RAM ? The display shows CALLING RAM momentarily as the panel dials the RAM

phone number in its memory. The display changes to SYSTEM PROGRAM when it has

connected to RAM.

At the conclusion of the programming session your system sends a report to the security company

and then returns your telephone to normal service and your display to idle text.

Table of Contents