Honeywell UDC3300 User Manual page 33

Function
Prompt
Lower Display
SOAK DEV Guaranteed Soak
Deviation Value
Program Termination State LASTSP (Hold at last setpoint in
PROG END
STATE Program State at Program
End
Reset SP Program
KEYRESET
HOT START Hot Start
SEG1RAMP or Segment #1 Ramp Time or
Segment #1 Ramp Rate
SEG1RATE
Segment #2 Soak Setpoint
SEG2 SP
Value
SEG2TIME Segment #2 Soak Duration 0-99 hours.0-59 minutes
Same as above
SEG 3, 5, 7, 9 &
11 RAMP
SEG 3, 5, 7, 9, &
11 RATE
SEG 4, 6, 8, 10 &
12 SP
SEG 4, 6, 8, 10 &
12 TIME
5/00
Function
Name
UDC3300 Basic Model: DC330B User Manual
Selections or
Range of Setting
Upper Display
0 to 99
The number selected will be the
PV value (in engineering units)
above or below the setpoint
outside of which the timer halts.
the program)
F SAFE (Manual mode/Failsafe
output)
DISABL
HOLD
DISABL
TOBEGN
RERUN
DISABL
ENAB
0-99 hours.0-59 minutes
Engineering units/minute or
Engineering units/hour
Select TIME, EU/MIN, or
EU/HR at prompt RAMPUNIT.
All ramps will use the same
selection.
Within the Setpoint limits
Selections are same as above.
Configuration
Factory
Setting
––
––
––
DISABL
DISABL
––
––
––
––
25