Using Two Sets Of Tuning Constants; Table 4-4 Setpoint Selection Indication; Table 4-5 Procedure For Selecting Two Sets Of Tuning Constants; Table 4-6 Procedure For Setting Switchover Values - Honeywell UDC3300 User Manual

Operation
Setpoint Selection Indication
Using Local
Upper PV and the PV
value
Display
Lower SP and the
Local Setpoint
Display
Value
Annunciator None

4.6 Using Two Sets of Tuning Constants

Select Two Sets or Gain Scheduling

Table 4-5 Procedure for Selecting Two Sets of Tuning Constants

Step Operation
Select
1
Control Set
Up group
Select PID
2
SETS
function
Set Switchover Value
If you select 2PV SW or 2SP SW, you must set a value at which the sets will switch
over. The procedure in Table 4-6 shows you how to set this value. This procedure
assumes that you are still in the Control Set Up group from Table 4-5.

Table 4-6 Procedure for Setting Switchover Values

Step Operation
Select
1
Switchover
value
function
44

Table 4-4 Setpoint Selection Indication

Using Remote
Setpoint Setpoint
SP RSP
PV and the PV
value
RSP and
Remote
Setpoint Value
" " lights
Press
until you see SET UP in Upper Display and CONTROL
SET UP
in Lower Display.
until you see the function desired in the Upper Display
FUNCTION
and PID SETS in the Lower Display.
LOOP 1/2
to select the type of PID SET.
or
Press
until you see the switchover value in the Upper Display
FUNCTION
and SW VALUE in the Lower Display.
LOOP 1/2
to select the switchover value in the upper display.
or
UDC3300 Basic Model: DC330B User Manual
Using 2nd Using 3rd Local
Local Setpoint
2SP
PV and the PV PV and the PV
value value
2SP and the 2nd 3SP and the 3rd
Local Setpoint Local Setpoint
Value Value
" " lights "3" lights
Action
Action
Setpoint
3SP
5/00