Sound Settings; Sensor Q-Foot For Embroidery - Viking Designer Ruby User Manual

Sensor Q-foot for embroidery

The Sensor Q-foot is always recommended for embroidery.
When using another type of foot, e.g., the R-foot,
deactivate Sensor Q-foot for embroidery.
Presser Foot Height for Embroidery
Adjust the height of the presser foot in embroidery stitch-
out mode.
Some embroideries may build up under the presser foot.
If there is not enough space between the presser foot and
the embroidery, the top thread will form loops on the
underside of the embroidery. Increase the presser foot
height in small steps until the embroidery moves freely
under the presser foot.

SOUND SETTINGS

You can change the Sound Settings on your machine to
alert you at a variety of situations. Select which sound
function you want to change. Then select the sound you
want to play by touching the icon. You will be able to hear
a preview of the sound when you touch the sound icon.
Each alert function can have a different sound. Close the
pop-up with the OK icon.
Audio Repeat
When active, the signal for some warning alerts or
attention pop-up messages is repeated in intervals until it is
cancelled.
Volume
You can change the volume using the slider bar. All sounds
settings will be affected if the volume setting is changed.
Presser Foot Height
for Embroidery
S & F
ETTINGS UNCTIONS
3:9