Bobbin Winding, Model 20 - Viking Designer Topaz User Manual

Bobbin Winding, model 20

Winding the bobbin with the
machine threaded
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin winder on the top
of the machine. The bobbin only ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Thread the machine with the main spool pin in the horizontal
position.
Note: If the thread spool is too large to be in horizontal position, wind
the bobbin as described under "Winding Specialty Threads" below.
3. Pull the thread from the needle under the presser foot and to
the right through the bobbin winding thread guide (C).
4. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
5. Push the bobbin winder to the right. A pop-up message
appears on the GraphicDisplay. Press the foot control or
the Start/Stop button to start winding. Hold the end of the
thread rmly when starting to wind. Once the bobbin begins
to wind, cut the excess thread.
When the bobbin is full, it will stop automatically. Push the
bobbin winder back to the left, remove the bobbin and cut
off the thread on the thread cutter.
Winding Specialty Threads
We do not recommend winding speciality threads such as
"invisible" or other stretchy threads, metallic or at metallic
threads through the needle.
Always wind these threads at minimum speed.
1. Place an empty bobbin on the bobbin winder on the top
of the machine. The bobbin only ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Place the large spool cap and a felt pad under the spool on the
main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through bobbin winding thread guide (C) as illustrated.
4. See Winding the bobbin with the machine threaded, step 4-5.
16
Set Up
Note: When using earlier version of HUSQVARNA
VIKING® bobbins that do not have a hole, wind several
turns of thread on the bobbin to get started.
A
B
Note: Depending on the type of thread, wrap the thread one or two
turns around the bobbin thread tension disc (B) to put more tension
on the thread. Embroidery weight bobbin thread should be taken two
turns around the bobbin thread tension disc.
C
D
C