Table of Contents
Advertisement
6. Taking Care of the Machine
Changing the light bulbs
Your sewing machine is equipped with two light bulbs. One is placed
under the sewing head and one above the free arm. Only use light
bulbs of a type as indicated on the front of the machine (24V, 5W).
They are available at your authorized HUSQVARNA VIKING®
dealer. Change the light bulbs as described below.
Turn off the ON/OFF switch.
1. Place the light bulb remover with the deep hole, marked OUT,
around the bulb. Do not turn the bulb, just pull it out to remove it.
2. When inserting a new light bulb place the remover with the
shallow hole, marked IN, around the new bulb. Insert the new
bulb by pushing it up.
Cleaning the machine
To keep your sewing machine operating well, clean it often. No
lubrication (oiling) is needed.
Wipe the exterior surfaces of your sewing machine with a soft cloth
to remove any dust or lint built up.
Turn off the ON/OFF switch.
Clean the Bobbin Area
Remove the presser foot and slide off the bobbin cover. Lower the
feed teeth. Place the screwdriver under the stitch plate as shown
in the picture and gently turn the screwdriver to pop off the stitch
plate. Clean the feed teeth with the brush.
Cleaning Under the Bobbin Area
After sewing several projects or any time you notice an accumulation
of lint in the bobbin case area, the area under the bobbin case must
be cleaned.
Remove the bobbin case holder (1) covering the front part of the
bobbin case. Remove the bobbin case (2) by lifting it up. Clean with
the brush. A small vacuum attachment works well to remove dust
and lint built up.
On model 30: Use caution when cleaning around the thread cut knife.
Put the bobbin case and the bobbin case holder back in place.
Note: Do not blow air into the bobbin case area. The dust and lint will be blown
into your machine.
Note: When using the optional accessory HUSQVARNA VIKING®
Embroidery Cutwork Needles, it is neccessary to clean the bobbin area after each
embroidered design/project.
Replacing the Stitch Plate
With feed teeth lowered, place the stitch plate so that it ts into
the notch at the back. Press the stitch plate down until it clicks into
place. Slide on bobbin cover.
68
Taking Care of the Machine
2
1
Advertisement
Table of Contents
