Threading For Twin Needles; Thread Sensor - Viking Designer Topaz User Manual

Threading for twin needles

1. Insert a twin needle.
2. Use a second thread spool or wind a bobbin with the thread
you are going to use as the second upper thread.
3. Lift the spool pin up and all the way to the right. Lock the
spool pin in the vertical position by slightly pressing it down.
Slide on the large spool cap. For spools smaller than the
medium size spool cap, place a felt pad under the thread
spool.
4. Place the rst thread spool on the spool pin. The spool
should rotate in a clockwise direction when the thread reels
off the spool.
5. LEFT NEEDLE: Thread the machine as described on page 13.
Check to ensure that the thread lies between the left thread
tension discs (A). Thread the left needle manually.
6. Pull out the auxiliary spool pin and slide on the large spool
cap. For spools smaller than the medium size spool cap, place
a felt pad under the thread spool.
7. Place the second thread on the spool pin. The second spool
should rotate in a counterclockwise direction when the thread
reels off the spool.
8. Thread the machine as before but this thread
RIGHT NEEDLE:
should lie between the right thread tension discs (A) and
outside the needle thread guide (B). Thread the right needle
manually.
Note: Only use symmetrical twin needles (C). Do not use this type of twin
needle (D), since it may damage your sewing machine.

Thread sensor

If the upper thread breaks or runs out or if the bobbin thread
runs out, the machine stops and a pop-up appears on the display.
If upper thread breaks: Re-thread the machine and press OK.
The pop-up disappears. If bobbin thread runs out; replace with a
full bobbin and continue sewing.
Set Up
A
C D
B
1
15