Programming - Viking Designer Topaz User Manual

Programming

The programming function on your machine makes it possible to
create stitches with your own personal settings and to combine
stitches and letters into stitch programs. You can add up to 40
stitches and letters in the same program. Save your own stitches
and programs in My Stitches and recall them any time you like.
All stitches in your sewing machine are programmable except
for buttonholes, darning, tapering stitches*, button sewing and
bartacks.
Create a stitch program
1. Press the PROG button to open the mode for programming.
2. The Stitch Menu which was previously selected will be kept
when entering the Programming Mode. To change the stitch
menu, press the Stitch Menu button and select another stitch
menu by using the arrow buttons.
3. Press the number of the stitch you wish to use. The stitch will
appear in Programming Mode.
4. Press the number of the next stitch and it will appear to the
right of the last entered stitch.
Note: Two numbers are displayed above the stitch program on the left
side of the GraphicDisplay. The rst number is the position of the
selected stitch in the program. The second number, put in brackets, is the
total number of stitches in the program. The number above the stitch
program on the right side of the GraphicDisplay is the number of the
selected stitch.
Add letters
5. Press the Font Menu button. Use the arrow buttons to select
a font and press OK. The machine will show the upper case
alphabet in Programming Mode.
6. Use the arrow buttons to select a letter and press OK to add
the letter to the program.
7. To switch to a lower case alphabet or numbers press the Shift
button.
About programming letters
Both upper and lower case letters will be stitched with a 7 mm
stitch width. If there are letters going below the baseline included
in the program (e.g. j, p, y) the height of the uppercase letters will
be reduced.
All text to be sewn out on the same project, should be in the
same program to ensure the letters are sewn out in the same
height.
For instance, a name and an address should be in the same
program with a STOP after the name.
*Only on model 30
Sewing Mode
Programming Mode
4.
6.
"Husqvarna" and "VIKING" have been programmed separately.
"Husqvarna" and "VIKING" are in the same program.
2
37