Delete Program; Commands Removed From Program - Viking Designer Topaz User Manual

Sewing Mode
Program too long to add more stitches
If you try to add more than 40 stitches or letters in the same
program this message is shown. Close the pop-up message by
pressing the OK button.
Note: If you add a FIX, STOP or a Selective Thread Cut* to the program
these will each use one memory space in the program.

Delete program?

This pop-up message will ask you to con rm when you have
choosen to delete an entire program in Programming Mode.
Select Yes or No with the arrow buttons and press OK.
The combination of commands is incorrect
If you are programming stitches or letters and try to insert any of
the commands STOP, FIX or Selective Thread Cut* into a stitch
program in an order that is not allowed, this message will appear.
Close the pop-up message by pressing the OK button.

Commands removed from program

If you try to insert a previously saved program into a new one or
if you are using the mirroring end to end* function on the whole
program, the result may be that the commands are put in an order
that is not allowed. To avoid this, the commands will be removed
from the program. Close the pop-up message by pressing the OK
button.
Overwrite?
If you choose to save a stitch or a program in a memory that
is not empty this message will appear asking if you wish to
overwrite the previously saved stitch/program with the new
one. Select Yes or No with the arrow buttons and press the OK
button.
Delete?
This message will ask you to con rm when you have selected to
delete a stitch or program from My Stitches. Select Yes or No
with the arrow buttons and press the OK button.
*Only on model 30
44