Camera Process [2/2] Menu Screen - JVC GY-HD110 Instructions Manual

MENU SCREENS

CAMERA PROCESS [2/2] Menu Screen

Item
WHITE CLIP
KNEE
LEVEL
MOTION SMOOTH
DNR
ADVANCED PROCESS..
PAGE BACK
68
Function/Setting (bold characters indicate initial settings)
Sets the white clipping point on input video signals with a high luminance level.
108% : The white clipping point is set at a luminance level of 108%.
100% : The white clipping point is set at a luminance level of 100%. If the screen is too white at
108%, set it to 100%.
Sets whether to run the "knee" function, which compresses video signals over a certain level to render the tonality
in the highlight areas, automatically or manually. Set "MANUAL" when you want to check the bright areas, and adjust
the knee point manually.
AUTO : Adjusts the knee point automatically, according to the luminance level.
MANUAL : You can change the luminance level in the "LEVEL" item.
Sets the start point for knee compression (knee point).
Increase the number : Raises the knee point level.
Decrease the number : Lowers the knee point level.
[Settings: 80%, 85%, 90%, 95%, 100%]
MEMO
When the "KNEE" item is set to "AUTO", "-----" is displayed and this cannot be selected.
Makes the video smoother when the tape is played back by adding frames to the signal recorded on the tape during
progressive shooting.
OFF : Does not function.
ON : Functions.
MEMO
This can be set when you select "HDV-HD30p", "HDV-HD25p", or "HDV-HD24p" in the "REC" item on the VIDEO
FORMAT menu screen.
When this cannot be set, "-----" is displayed.
Selects whether or not to set the noise reduction.
The DNR (Digital Noise Reduction) function is applied to the tape recording signal, component output signal, and the
IEEE1394 output signal in CAMERA mode.
OFF : Noise reduction is not performed.
ON : Sets noise reduction.
MEMO
• DNR is not applied in VTR mode or during playback.
• DNR is not applied to composite output signals in CAMERA mode.
• When the DNR is set to ON, the camcorder's S/N ratio becomes better but the "blurring of moving objects" will
increase.
Calls up the ADVANCED PROCESS menu screen.
X See "ADVANCED PROCESS Menu Screen" on page 69.
When the cursor is in this position, press the SHUTTER dial to return to the CAMERA PROCESS [1/2] menu screen.