Synchronizing With The Time Code Of The Ieee1394 (Dv)-Connected Master Unit; Ieee1394 (Dv)-Connected Master Unit - JVC GY-HD110 Instructions Manual

PREPARATIONS FOR OPERATION

Synchronizing with the Time Code of the IEEE1394 (DV)-Connected Master Unit

You can synchronize the time code when performing multi-camera recording. The internal time code generator will be synchro-
nized with the time code in the signal input from the IEEE 1394 terminal. After synchronization (slave lock), the internal time code
generator continues to run even if the IEEE1394 cable is disconnected.
Master unit
Slide the
switch to the [DV] side.
* You can use the GY-HD110U or GY-HD111E as a slave unit. You cannot use the GY-HD110E as a slave unit.
Connections
Connect the master unit and the slave unit with an IEEE1394 cable.
Settings and Operations
• Master unit (GY-HD100U/GY-HD100E/GY-HD101E/GY-HD110U/GY-HD110E/GY-HD111E)
1.
Set the IEEE1394 switch on the left side to [DV].
2.
Set to Camera mode.
3.
Set the recording format to DV-60I or DV50I.
4.
Set the TC GENE. switch to [FREE].
• Slave unit (GY-HD110U/GY-HD111E)
1.
Set the IEEE1394 switch on the left side to [DV].
2.
Set to VTR mode.
3.
Check that the camera image from the master unit is input.
4.
Set the TC GENE. switch to [FREE] and the TC DISPLAY switch to [TC].
5.
Set to STOP mode or EJECT mode.
6.
Press the STOP button for 1 second.
• The DV input time code data from the IEEE1394 terminal is displayed in the status
display. (When status is in magnified size, images and characters are displayed.)
7.
Press the USER1 button to begin slave lock.
(To skip slave lock, press the USER3 button and clear the status display.)
8.
Check that the time code that is synchronized with the master unit is running.
9.
Disconnect the IEEE1394 cable.
MEMO
Slave lock cannot be performed in the following instances.
• Slave unit is in CAMERA mode
• Slave unit is in VTR mode and there is no DV signal
• The TC GENE. switch on the slave unit is not set to FREE
• The slave unit is GY-HD110E
• HDV format
If slave lock is performed in DV format and is then switched to HDV format, frame digit may deviate.
If power is turned off, slave lock is disabled. Perform slave lock operation again.
Slave lock cannot be performed for UB (User's bit).
If the frame rate for the master unit and slave unit is not synchronized, it will not run properly. Synchronize frame rate before
using.
If DROP/NON DROP is not synchronized, it will not run properly. Synchronize DROP/NON DROP before using.
42
IEEE1394 IEEE1394 terminal
Slave unit
IEEE1394 terminal
IEEE1394 cable
Slide the IEEE1394
switch to the [DV] side.
Status display
DTCG 00 : 00 : 00 : 00
TC SLAVE LOCK ?
EXECUTE USER1
CANCEL USER3