Basic Function Commands
Correction Subsystem ([:SOURce]:CORRection)
:FLATness:STEP:STARt
Supported
All Models
[:SOURce]:CORRection:FLATness:STEP:STARt <freq><unit> |MAXimum|MINimum|DEFault|
[:SOURce]:CORRection:FLATness:STEP:STARt? [MAXimum|MINimum]
This command sets the start frequency for the user flatness calibration step array. See also,
:FLATness:STEP:POINts
*RST
The preset value is model/option dependent. Refer to the instrument's Data Sheet.
Range
The range is model/option dependent. Refer to the instrument's Data Sheet.
Key Entry
Freq Start
:FLATness:STEP:STOP
Supported
All Models
[:SOURce]:CORRection:FLATness:STEP:STOP <freq><unit> |MAXimum|MINimum|DEFault|
[:SOURce]:CORRection:FLATness:STEP:STOP? [MAXimum|MINimum]
This command sets the stop frequency for the user flatness calibration step array. See also,
:FLATness:STEP:POINts
*RST
The preset value is model/option dependent. Refer to the instrument's Data Sheet.
Range
The range is model/option dependent. Refer to the instrument's Data Sheet.
Key Entry
Freq Stop
:FLATness:STORe
Supported
All Models
[:SOURce]:CORRection:FLATness:STORe "<file name>"
This command stores the current user–flatness correction data to a file named by the
:CORRection:FLATness:STORe command. The directory path is implied in the command and need
not be specified in the "<file name>" variable.
Key Entry
Store To File
Remarks
For information on file name syntax, refer to
:PMETer:CHANnel
Supported
All Models
[:SOURce]:CORRection:PMETer:CHANnel A|B
[:SOURce]:CORRection:PMETer:CHANnel?
This command selects the channel setting on the external power meter for user flatness calibration.
Default
Channel A
Key Entry
Power Meter Channel A B
22
and
:FLATness:STEP:STOP
and
:FLATness:STEP:STARt
commands.
commands.
"File Name Variables" on page
Agilent X-Series Signal Generators SCPI Command Reference
13.