Correction Subsystem ([:Source]:Correction); Flatness:frequency; Flatness:initialize:fstep; Flatness:load - Agilent Technologies N5171B Command Reference Manual

Basic Function Commands

Correction Subsystem ([:SOURce]:CORRection)

Correction Subsystem ([:SOURce]:CORRection)

:FLATness:FREQuency

Supported
All Models
[:SOURce]:CORRection:FLATness:FREQuency? <point>
This command returns the frequency value of the <point> queried.
Range 1 to 3,201
# Points
Key Entry

:FLATness:INITialize:FSTep

Supported All Models
CAUTION The current flatness data will be overwritten once this command is executed. If needed,
save the current data. Refer to the
files.
[:SOURce]:CORRection:FLATness:INITialize:FSTep
This command replaces the loaded user flatness data with the settings from the current step array
data points.
The maximum number of user flatness points is 3,201. When copying the step array settings over to
a user flatness file, ensure that the number of points in the step array do not exceed the maximum
user flatness points.
See also ":FLATness:STEP:POINts" on page
Range 1 to 3,201
Key Entry Load Cal Array From Step Array

:FLATness:LOAD

Supported All Models
[:SOURce]:CORRection:FLATness:LOAD "<file name>"
This command loads a user–flatness correction file. The "<file name>" variable is the name of the file
located in the Catalog of USERFLAT Files. The directory path is implied in the command and need
not be specified in the file name parameter. For more information on file name syntax, refer to
Name Variables" on page
Key Entry Load From Selected File
20
21.
13.
:FLATness:STORe command for storing user flatness
Agilent X-Series Signal Generators SCPI Command Reference
"File