Setup:table - Agilent Technologies N5171B Command Reference Manual

Arb Commands
Multitone Subsystem–N5172B/82B ([:SOURce]:RADio:MTONe:ARB)
This command stores the current multitone waveform setup in the signal generator file system of
MTONE files.
Key Entry Store To File

:SETup:TABLe

Supported N5172B/82B
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe <freq_spacing>,
<num_tones>,<phase>,<state>
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe?
This command creates and configures a multitone waveform.
The frequency offset, power, phase, and state value are returned when a query is initiated. The
output format is as follows:
<frequency offset>,<power>,<phase>,<state>
The variable <freq_spacing> is expressed in units of Hertz (Hz–MHz).
The variable <power> is expressed in units of decibels (dB).
*RST Tone
Tone 1 - 35000
Tone 2 - 25000
Tone 3 - 15000
Tone 4 - 5000
Tone 5 +5000
Tone 6 +15000
Tone 7 +25000
Tone 8 +35000
Range <freq_spacing> (2 tones): 1E1 to Option 65x bandwidth
<num_tones>: 2–64
<freq_spacing> (>2 tones): 1E1 to (Option 65x bandwidth  (num_tones  1))
<phase>: 0–359
BBG_max_bandwidth:
653: 60 MHz
655: 120 MHz
656: 80 MHz
657: 160 MHz
Freq Spacing
Key Entry
NOTE The Toggle State softkey has a different softkey path but the same SCPI command when
initializing the Multitone table (For the softkey path, refer to
page 326).
Remarks To set the frequency spacing, refer to
324
<frequency offset> <power>
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
+0.00000000E+000
Number Of Tones
<phase>
+0
+0
+0
+0
+0
+0
+0
+0
Toggle State
":SETup:TABLe:ROW" on
":SETup:TABLe:FSPacing" on page
Agilent X-Series Signal Generators SCPI Command Reference
<state>
+1
+1
+1
+1
+1
+1
+1
+1
325.