Section 2-Assembly; Assembling The Patient Lift; Assembling The Mast Assembly To The Base - Invacare JASMINE Owner's Manual

SECTION 2—ASSEMBLY
SECTION 2—ASSEMBLY

Assembling the Patient Lift

Assembling the Mast Assembly to the Base

NOTE: The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be properly
secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1. Put the base on a level surface so all casters make
contact with the floor.
2. Lock the rear casters. Refer to Detail "A".
3. Unscrew the top knob and remove it from the base.
4. Loosen the bottom knob, but leave it screwed into the
base.
5. Put the tube of the mast assembly into the hole in the
base.
6. While supporting the mast assembly, tighten the
bottom plastic knob.
7. Screw the top plastic knob into the hole in the base.
Jasmine™ Patient Lift
DETAIL "A"
Push tab down to lock
Push tab up to unlock
Base
Caster
FIGURE 2.1 Assembling the Mast Assembly to the Base
10
Mast
Assembly
Top Plastic Knob
Bottom Plastic Knob
Part No 1150704