Convection Motor And Heater Element Removal (Select Models); Convection Heater Element Removal (Select Models); Light Socket Removal; Grille Heater Element Removal (Select Models) - Maytag UMV1152CA Manual

Disassembly Procedures
!
W A RN ING
Convection Motor and Heater Element
Removal (Select Models)
1. Disconnect power to oven.
2. Discharge high voltage capacitor, see "High Voltage
Capacitor Removal" procedure.
3. Remove outer case, see "Outer Case Removal"
procedure.
4. Remove screws securing back cover and pull the top
of back cover downward, sliding right side metal tab
from oven cavity.
5. Remove screws securing air duct to chassis and
other components.
6. Label and disconnect wire leads from air duct.
7. Remove magnetron see "Magnetron Removal"
procedure.
8. Remove screws securing bottom plate to chassis.
9. Disconnect wire leads from convection chamber.
10.Remove screws securing convection chamber
assembly and lift assembly from oven cavity.
11. Slide inner convection fan blade off convection motor
shaft.
12.Remove nuts securing convection motor to bracket.
13.Replace and reassembly in reverse order.
Convection Heater Element Removal
(Select Models)
1. See "Convection Motor Removal;" perform steps 1
through 9.
2. Remove screws at and next to terminals securing
wires and element to heater box.
3. Release metal clip securing element to heater box.
4. Remove element from heater box.
5. Replace and reassembly in reverse order.
38
To avoid risk of electrical shock, personal injury or
death; disconnect power to microwave oven and
discharge the high voltage capacitor before performing
any disassembly procedures.

Light Socket Removal

1. Disconnect power to oven.
2. Remove Grille, see "Grille Removal" procedure.
3. Remove screws securing bulb holder.
4. Remove light bulb and socket.
5. Disconnect wire terminal plug.
6. Replace and reassemble in reverse order.
Grille Heater Element Removal
(Select Models)
1. Disconnect power to oven.
2. Discharge high voltage capacitor, see "High Voltage
Capacitor Removal" procedure.
3. Remove outer case, see "Outer Case Removal"
procedure.
4. Remove screws securing back cover and pull the top
of back cover downward sliding metal tab on right
side from oven cavity.
5. Remove screws securing air duct to chassis and
other components.
6. Disconnect wire leads from air duct.
7. Remove screw securing upper insulator.
8. Remove screws securing the heater terminal and
heater barrier.
9. Remove screws securing the heater holding bracket.
10.Remove grille heater from cavity.
11. Replace and reassembly in reverse order.
16027303
© 2006 Maytag Services