Turntable Motor Removal; Vent Blower Removal - Maytag UMV1152CA Manual

Disassembly Procedures
!
W ARNING

Turntable Motor Removal

1. Disconnect power to oven.
2. Remove screws securing bottom plate cover.
3. Open the oven door, remove turntable, and gently pry
upward on turntable shaft.
4. Disconnect wire leads from turntable motor.
5. Remove screws securing turntable to the oven cavity.
6. Replace and reassemble in reverse order.
© 2006 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power to microwave oven and
discharge the high voltage capacitor before performing
any disassembly procedures.

Vent Blower Removal

Vent blower is a five speed capacitor run blower
assembly located on top of the oven. The blower is
operated by voltage relays located on the circuit board.
Vent Exhaust Blower Removal
1. Disconnect power to unit and remove unit from its
installation.
2. Remove screws securing damper and motor
assembly to top and back of unit.
3. Remove damper.
4. Lift blower assembly out and disconnect wire
connection wire terminal.
5. Reassemble in reverse order.
NOTE: Place blower assembly wires in slotted area to
avoid pinching of wires.
16027303
Damper ASM
Blower ASM
37