Maytag UMV1152CA Manual page 52

Installation Instructions
A3.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1–3. Do not pinch cord
or lift oven by pulling cord.
2.
Rotate front of oven
up against cabinet
bottom
3.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord,
A – 14
Installation Instructions
1.
Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
16027303
especially when mounting flush to bottom of
cabinet.
Cabinet Front
Cabinet Bottom Shelf
Microwave Oven Top
4.
Attach the microwave oven to the top cabinet.
5.
Insert 2 self-aligning screws through outer
top cabinet holes. Turn two full turns on
each screw.
7.
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
8.
Install grease filters. See the Owner's Manual
packed with the microwave.
13
Filler Block
Equivalent to
Depth of
Cabinet Recess
Self-Aligning Screw
6.
Tighten center
screw completely.
© 2006 Maytag Services