Splatter Shield Removal; Antenna And Cradle; Blower Motor Or Wheel Removal; Door Disassembly - Maytag RS511 Service Manual

Disassembly Procedures
!

Splatter Shield Removal

NOTE: Be careful not to bend antenna when removing
splatter shield. Shield snaps into a lip in front of
the oven and three slots in back.
1. Place your thumbs in the two indentations in front of
the shield.
2. Press lightly towards the back and carefully lower
shield away from antenna.
3. Pull shield out of the back slots and tilt sideways to
remove from oven cavity.

Antenna and Cradle

NOTE: Antenna assembly is mounted in a cradle. The
antenna is located in a plastic tower in the
middle of the cradle.
1. Remove outer case and splatter shield.
2. Remove two mounting nuts on top of oven cavity to
remove cradle. Support cradle before removing
mounting nuts to avoid damage to antenna
assembly.
Larger end of
cradle goes to
left rear side
of cavity.
Cradle
Rotating Antenna Installation
NOTE: Antenna and cradle must be free of any burrs
for proper operation.
1. Carefully place antenna onto cradle tower.
2. Position cradle into mounting holes in cavity with
larger end toward back and install mounting nuts.
Be careful not to overtighten.

Blower Motor or Wheel Removal

NOTE: Blower wheel does not have set screw but has a
"D" type hole in the hub and clip on end of motor
shaft.
1. Disconnect power to oven.
2. Remove outer case, see "Outer Case Removal"
procedure.
3. Disconnect wiring from blower motor.
4. Remove screw securing scroll bottom to partition.
©2002 Maytag Appliances Company
WARNING
Antenna
Cradle
tower
To avoid risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Blower
Scroll
Scroll
Bottom
5. Remove screws from base pan bottom to plastic
scroll legs.
6. Slide scroll discharge from partition and lift scroll
assembly from unit.
7. Unsnap metal bottom from scroll.
8. Remove blower wheel clip and wheel.
9. Remove motor mounting screws from scroll.

Door Disassembly

Old Door Assembly
(unit with P13258* manufacturing number)
1. Open door fully.
2. Remove ten Y–drive screws from inner door. (Use
R0193574 driver.)
3. Remove inner door.
4. Remove handle insert and handle.
5. Remove outer door.
6. Remove door ring and latch handle assembly by
removing screws on side of the door.
Door
hinge
Outer
door
Outer
window
Gasket
Retainer
lens
Handle
insert
*Use Manual Driver Part Number R0193574.
16021518 Rev. 0
Blower
Motor
Blower
Wheel
Inner
Door
door
ring
Inner
weld
window
Door
Door latch
latch
assembly
spring
Door
handle
Rivet
21