Turntable Motor; Vent Blower; Light Socket - Maytag UMV1152BAB/W/Q/S Service

Disassembly Procedures
!
W AR NIN G

Turntable Motor

1. Disconnect power to oven.
2. Remove screws securing bottom plate cover.
3. Open the oven door, remove turntable, and gently pry
upward on turntable shaft.
4. Disconnect wire leads from turntable motor.
5. Remove screws securing turntable to the oven cavity.
6. Replace and reassemble in reverse order.
40
Wire leads
Turntable motor
16023056 Rev. 0
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Vent Blower

Vent blower is a five speed capacitor run blower
assembly located on top of the oven. The blower is
operated by voltage relays located on the p.c. board.
Vent Exhaust Blower Removal
1. Disconnect power to unit and remove unit from its
installation.
2. Remove screws securing damper and motor
assembly to top and back of unit.
Blower
unit
Blower unit
mounting screw
3. Remove damper.
4. Lift blower assembly out and disconnect wire
connection wire terminal.
5. Reassemble in reverse order.
NOTE: Place blower assembly wires in slotted area to
avoid pinching of wires.

Light Socket

1. Disconnect power to oven.
2. Remove Grille (see "Grille" procedure).
3. Remove screws securing bulb holder.
4. Remove light bulb and socket.
5. Disconnect wire terminal plug.
6. Replace and reassemble in reverse order.
Blower
plate
B
B
©2004 Maytag Services