•
After fitting a new expansion vessel, fill
and purge the appliance or installation
if necessary.
15.4 Ignition module / Ignition and
control electrode / Sight glass
1
2
3
4
Legend
1
Ignition module
2
Ignition module harness connector
3
Ignition module retaining screw
4
Ignition and control electrode
connector
5
Ignition and control electrode
6
Ignition and control electrode retaining
screw
7
Circlip
8
Gasket
9
Sight glass
10
Gasket
11
Spring leaf
15.4.1
Ignition module
•
Remove the ignition and control
electrode connector (4) from the ignition
module (1).
•
Remove the ignition module harness
connector (2).
•
Remove the 2 ignition module (1)
retaining screws (3).
•
Fit the new ignition module by repeating
the operations in reverse.
11
10
5
9
6
7
8
15.4.2
Ignition and control electrode
•
Remove the ignition and control
electrode connector (4) from the ignition
module (1).
•
Remove the 2 ignition and control
electrode (5) retaining screws (6).
•
Fit the new ignition and control
electrode by repeating the operations in
reverse.
15.4.3
Sight glass
•
Remove the circlip (7).
•
Remove gaskets (8) and (10), the sight
glass (9) and the spring leaf (11).
•
Fit the new sight glass and the new
gaskets by repeating the operations in
reverse.