Gas And Water Connection - Saunier Duval Thema CONDENS F 18 E SB Instructions For Use Installation And Servicing

• Chose the location of the appliance.
See chapter "Appliance location".
The hanging bracket will be adapted to
the features of the bearing wall and will
have to take into account the weight of the
boiler filled with water.
• Drill the holes for the fixing screws
in accordance to the diagram below
and to the size of the wall template
delivered with the appliance.
=320=
811 748
70
102
• Place the boiler above the hanging
bracket.
• Slowly lower the boiler.
• Set the seals on the different pipe
fittings.
• Make connections to boiler, gas,
water and heating cocks with the tube
assemblies supplied in piping pack.
• Do not forget to connect the 2
filling loop extensions on the 2
filling taps. (*)
(*) Not required for SB models
5.6
• Before undertaking any operation,
carefully clean the pipes with an
appropriate product in order to remove
impurities such as filings, welds,
different oils and greases that may be
present.
These foreign bodies may enter the
boiler and disrupt the operation.
• Do not use any solvents that could
damage the heating circuit.
Ø105
• Take care when soldering pipes as the
heat could damage the seals and cause
leakage. Fit washers after joints have
cooled.
The pipe from the heating safety
discharge valve must not discharge above
an entrance, window or any type of public
5 access area.
min.
• Only use the genuine seals delivered
with the appliance.
• Check that there is no leakage. Repair
if need be.
Take the short safety discharge tube,
GAZ
GAS
union nut and seal, supplied loose in
the boiler fittings pack.
38
37
This must be extended, using not less
70
than 15mm o.d. pipe, to discharge, in a
visible position, outside the building, facing
downwards, preferably over a drain.
The pipe must have a continuous fall
and be routed to a position so that any
discharge of water, possibly boiling, or
steam cannot create any danger to
persons, damage to property or external
electrical components and wiring.
To ease future servicing it is advisable to
use a compression type fitting to extend
the safety discharge valve tube.

Gas and water connection