Frost Protection - Saunier Duval Thema CONDENS F 18 E SB Instructions For Use Installation And Servicing

12 Frost protection

12.1 Boiler frost protection
In case of frost risk, do as follows:
• Make sure the boiler is supplied with
electrical power and gas.
• Select the operating mode on the
control panel.
The frost protection system orders the
pump to start as soon as the temperature
in the heating circuit falls below 8°C. The
pump stops as soon as the temperature of
the water contained in the heating circuit
reaches 10°C.
If the temperature in the heating system
falls below 5°C, the burner ignites until it
reaches 35°C.
12.2 Installation frost protection
• If you leave home for a few days, select
the minimum heating temperature on
the control panel of the boiler and just
decrease the setpoint temperature on
your room thermostat.
• If you leave home for a long period, see
chapter "Draining of the appliance" in
the installation manual.
13 Maintenance/After Sales Service
Please note that incorrect servicing can
affect the safety of the appliance and can
lead to injury.
To ensure the continued efficient and
safe operation of the appliance it is
recommended that it is checked and
serviced as necessary at regular intervals.
The frequency of servicing will depend
upon the particular installation conditions
and usage, refer to guarantee registration.
If this appliance is installed in a rented
property there is a duty of care imposed
on the owner of the property by the current
issue of the Gas Safety (Installation and
Use) Regulations, Section 35. Servicing/
maintenance should be carried out by
a competent person in accordance with
the rules in force in the countries of
destination. To obtain service, please call
your installer or Saunier Duval service.
10