Operating The Boiler (User Instructions); Control Panel; Commissioning And Lighting; To Program Daily Timeclock - Saunier Duval Semia Condens F24 E Instructions For Use Installation And Servicing

6 Operating the boiler (user instructions)

6.1

Control panel

9
8
Legend
1 Operating indicator
2 Operating mode selection
3 Heating temperature adjustment
4 DHW temperature adjustment
5 Display of the temperature /
error codes
6.2

Commissioning and lighting

• Make sure that:
- the boiler is connected to the electrical
supply (the green indicator [1] blinks).
- the gas service cock is open.
• Turn the selector [2] bringing it in the
SUMMER or WINTER
The operating indicator [1] on the
control panel turns on: the boiler is
ready to run.
• Turn the selector [2] to modify the
operating mode of the boiler:
Central heating and
domestic hot water
Domestic hot water only
Installer mode
0 Stand-by and appliance
reset frost protection
5
1 7
2 3
10
position.
4
6 Pressure gauge
7 Safety lockout indicator
8 Timeclock
9 Timeclock toggles
10 Timeclock mode selector
6.3

To program daily timeclock

Set the current time, by turning the dial [8]
clockwise until the current time is shown
against the indicator ' '.
Push in plastic toggles [9] against the time
you wish the heating to be off.
The timeclock can operate in three
positions: automatic '
permanently off '0', and heating
permanently on '1'.
To select, move the lever [10] to the
desired position.
NOTE: In case the electrical supply fails
the timeclock will not operate as
it has no back-up battery backup.
Therefore, it will be necessary
to reset the current time once
electrical supply is restored.
5
6
', heating