Husqvarna 36 Workshop Manual page 69

Assembly
Grease the needle bearing (C) and fit onto
the crankshaft. Then fit the clutch drum.
NOTE! The bearing can also be greased
later through the hole on the crankshaft.
To prevent imbalance all clutch shoes should
be replaced at the same time.
Saws with three
coil springs.
Locate the clutch shoes on
the hub and fit the springs
with the help of pliers.
Using a spanner secure the clutch centre.
On saws 36 and 41 use service tool no.
530 03 11-12.
Note! Left-hand thread.
Remove the piston stop and fit the spark
plug.
CENTRIFUGAL CLUTCH
Saws with one
Saws with three C-springs.
long spring.
Locate the clutch shoes on the
hub. Lift a shoe using a suit-
able spacer (A) and fit the
spring.
Locate the clutch shoes on the
hub and fit the springs with the
help of circlip pliers.
A
Fit the chain and bar. See the operating instruc-
tions. On 268K and 272K, fit the cutting attach-
ment.
See the operating instructions.
C
NOTE! The clutch
springs should not be
opened out more than
necessary. Risk of
deformation.
69
English –