Husqvarna 36 Workshop Manual page 60

Grease the return spring and starter pulley
bearing.
If the starter unit has a cover plate (B) over
the spring, fit the plate.
Fit the starter pulley. Rotate back and forth
until the starter pulley catches in the spring.
Fit the starter pulley washer and bolt and
tighten the bolt to 4 Nm.
If the starter has a cord guide (A), fit this.
Pull out the cord through the hole in the cover
and fit the handle, secure with a double knot.
Pull out the cord 20-30 cm and insert it into
the cut-out on the starter pulley rim. Some
saws have several long cut-outs.
Rotate the starter pulley clockwise until the
cord is correctly tensioned.
Check the cord tension
A. Pull out the cord completely and hold the
pulley with your thumb.
B. In this position it should be possible to turn
the starter pulley a further 1/2 - 3/4 turn.
Fit the starter on the crankcase. Tighten the
bolts to 4 Nm.
60
– English
STARTER
B
A