Husqvarna 36 Workshop Manual page 117

CRANKCASE AND CRANKSHAFT
Assembly
Saws 36 and 41.
Fit the bearing and seals on the crankshaft.
Grease the seals.
Continue assembly as described on
page 111.
NOTE!
Ensure that dirt and foreign particles
do not enter the bearing.
If new seals need to be fitted in the
crankcase, grease the sealing surfaces
and knock in the seals using respective
punchs (see "Service tools").
The seals can also be fitted when the
crankcase is in position.
Assembly position. See pages 123 and 124.
See continuation on next page.
Saws 40 and 45.
See page 120.
!
If the bearing needs to be fitted proceed
as follows:
A. Heat the crankcase half in question to
200°C.
B. Wear protective gloves, take out the
crankcase half and press in the bearing.
C. Let the crankcase half cool before
continuing work.
Other saws
WARNING!
The crankcase halves can be hot.
Risk of burns. Wear protective
gloves.
117
English –