Fitting The Spark Plug Cover - Husqvarna 36 Workshop Manual

• Insert feeler gauge 502 51 34-02
(0.3 mm) between the ignition module
and the flywheel's magnet.
• Push the ignition module towards the
flywheel and tighten the bolts to 4 Nm.
Fit the guide rail, insert the cables and fit
the cable to the ignition module.
Saws 42, 242, 246, 281 and 288.
Fit the ignition coil, which is located next to
the carburettor and connect the cables.
Fit the starter and cylinder cover.

Fitting the spark plug cover

Make a hole in the HT cable using pliers
502 50 06-01.
Push the HT cable through the spark plug
cover and fit the contact spring using the
pliers.
Slide the spark plug cover over the contact
spring.
Stop switch
The stop switch is described in the section
"Safety equipment". See page 51.
64
– English
ELECTRICAL SYSTEM
Other saws.
Fit the starter and cylinder cover.