Husqvarna 36 Workshop Manual page 111

Assembly
NOTE!
Ensure that no dirt or other foreign particles
fall into the crankcase.
Oil the needle bearing and fit it into the
connecting rod little end.
Refit the piston with the arrow facing the
exhaust port.
Slide in the gudgeon pin and fit the circlip.
Saws 36, 40, 41 and 45
Oil the piston and piston ring.
Compress the piston ring either by hand or
by using tool 502 50 70-01. Carefully fit
the cylinder.
Saws 36 and 41
Apply silicone rubber 504 98
26-01 to the lower crank-
case half's contact surfaces.
Check that the seals fit in
their grooves correctly.
Tighten the crankcase
halves. Tightening torque
refer to "Service data".
PISTON AND CYLINDER
Other saws
Fit a new cylinder gasket
See continuation on next page.
111
English –