Husqvarna 36 Workshop Manual page 118

CRANKCASE AND CRANKSHAFT
Saw 40 and 45.
See page 120.
Grease and fit a new crankcase gasket (A).
Check that the guide pin (B) is in position and
fit the other crankcase half.
NOTE!
Continuing to pull with the assembly
tool after the gasket is clamped will
damage the crankshaft.
Using the assembly tool for the chain saw in
question, fit the two crankcase halves. Pull
until the gasket is clamped between the two
crankcase halves.
See continuation on next page.
118
– English
Other saws.
NOTE!
Ensure that the connecting rod does
not jam against the crankcase when
the crankcase and crankshaft are
assembled.
Using the assembly tool for the chain saw in
question assemble the crankshaft in the
clutch side's crankcase half.
Some saws have a sharp edge on the crank-
shaft which can damage the seal. The as-
sembly sleeve should be used when working
on these saws. See "Tools".
NOTE! Place the oil tank's vent hose in
the pocket above the tank cap in the
equivalent crankcase half.