Husqvarna 36 Workshop Manual page 123

CRANKCASE AND CRANKSHAFT
Assembly
Seal assembly in the oil pump
1. Place the oil pump on a sleeve (A) with
an inner diameter greater than the
seal's outer diameter.
2. Fit the seal (B) using the assembly
punch so that the surfaces (C), are
level.
Seal assembly in the plastic flange
1. Place the plastic flange on a flat and
firm surface.
2. Fit the seal using the assembly punch
until it bottoms on the flange shoulder.
Seal assembly in the crankcase
Some saws have a sharp edge on the crank-
shaft which can damage the seal. The as-
sembly sleeve should be used when working
on these saws. See "Tools".
1. Fit the seal using the assembly
mandrel.
2. The seal should be fitted using the
measurements for each saw as shown
in the instructions on the next page.
After fitting the seal assemble:
On the starter side:
• Starter
• Flywheel
• Generator (if fitted)
On the clutch side:
• Chain and bar
• Oil pump
B
A
C
123
English –