11
SERVICE WORK ON THE CHASSIS
11.37
Adjusting the chain guide
Info
The size of the chain wheel varies with the number of teeth. The chain guide can be adjusted on small sprockets.
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check the chain sliding piece for tightness.
»
If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Remaining screws, chassis
B00383-10
–
Measure the material thickness
Minimum distance
position
»
If distance
–
Change the chain guide.
B00384-10
–
Check the chain guide for tightness.
»
If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
B00385-01
Finishing work
–
Install the chain guard. (
–
Remove the motorcycle from the lift stand. (
x
Preparatory work
–
Remove the chain guard. (
Main work
–
Loosen screw
–
Position the chain guide.
–
Tighten screw.
Guideline
Remaining screws, chassis
700459-01
x
on the bottom of the chain guide.
B
at the lowest
B
is less than the specified measurement:
B
x
p. 40)
p. 40)
.
1
M8
25 Nm
(18.4 lbf ft)
13 mm (0.51 in)
M6
10 Nm
(7.4 lbf ft)
p. 27)
M6
10 Nm (7.4 lbf ft)
44