11
SERVICE WORK ON THE CHASSIS
11.12
Adjusting the play of the steering head bearing
11.13
Greasing the steering head bearing
11.14
Dismounting the start number plate
»
If click positions are noticeable:
–
Adjust the play of the steering head bearing.
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove fuel tank breather
–
Loosen screws
–
Loosen screw
–
Loosen and retighten nut
Guideline
Nut, steering stem
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
C00021-10
–
Tighten screw
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, top triple clamp
–
Position the fuel tank breather
Finishing work
–
Check play of steering head bearing. (
–
Remove the motorcycle from the lift stand. (
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
300669-01
–
Remove screw
–
Remove screw
602672-10
x
.
1
.
2
.
3
.
4
.
3
.
2
.
1
(
p. 30)
x
x
(
p. 31)
and take off clamp.
1
. Remove the start number plate.
2
(
p. 33)
x
p. 27)
p. 27)
M20x1.5
10 Nm (7.4 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
p. 32)
p. 27)
33