Connecting Wires To Terminals - Kenwood KDC-U546BT Instruction Manual

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo type and
does not have any resistance.
Fuse (10A)
Wiring harness
(Accessory1)
Motor antenna control wire(Blue)
Mute control wire (Brown)
Steering remote control wire
(Light Blue/Yellow)
Power control wire (Blue/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
32
|
KDC-U546BT
USB connector
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
If no connections are made, do not let the wire come out from the tab.
Depending on what antenna you are using, connect either to the control
ANT. CONT
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
To connect the Kenwood navigation system, consult your navigation
MUTE
manual.
To use the steering wheel remote control feature, you need to an
REMOTE CONT
exclusive remote adapter (not supplied) matches your car is required.
STEERING WHEEL
REMOTE INPUT
Connect either to the power control terminal when using the optional
P.CONT
power amplifier.
Car fuse
box
ACC
R L
Rear output/Sub Woofer output
Switches the preout between rear output ("REAR") and subwoofer
output ("SUB-W"). Refer to "SWITCH PREOUT" of <Initial Setting>
(page 18).
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
Car fuse box
(Main fuse)
+ Battery
–
FM/AM antenna input
Front output