Contents Before use Before use ..........2 2 WARNING To prevent injury or fire, take the Preparations ..........4 following precautions: • Stop the car before operating the unit. Basic operations ........5 • To prevent a short circuit, never put or leave any metallic objects (such as coins Playing music (CD/USB/iPod)....
Kenwood dealer. • When you purchase optional accessories, • The following discs cannot be used: check with your Kenwood dealer to make - Discs that are not round sure that they work with your model and - Discs with coloring on the recording in your area.
Preparations Release Control knob (Volume knob) [DISP] Exit Demonstration Mode Detaching/ Reattaching the Turn off the demonstration mode Faceplate when you use it for the first time after installation. Press the Control knob to quit the demonstration mode when the messages “To Cancel DEMO Press the volume knob”...
Basic operations KDC-U7049BT KDC-U6049 KDC-U7049BTL KDC-U6049L [ ] [ ] [iPod] USB terminal [SRC] Control knob Auxiliary input [DISP] [LOG] Power Auxiliary input Turn the power ON by pressing the Portable audio device can be connected [SRC] button. with the stereo mini-plug (3.5 mm ø).
Playing music (CD/USB/iPod) [SRC] Control knob Disc slot USB Terminal Playing disc Music search Insert the disc in the Disc slot. Searching for the song you want to play. When inserted, the source is switched Press the [ ] button. automatically and a song starts playing.
Listening to the radio [SRC] [PRESET] Control knob Selecting a tuner source and then press the Control knob for at least 2 seconds. Press the [SRC] button to select “TUNER”. Recalling the stations in the Selecting the band Push the Control knob towards down to memory change the band (FM or AM).
Function of KDC-U7049BT, KDC-U7049BTL, KCA-BT200/BT300 (Optional Accessory) Hands-free phoning KDC-U6049 KDC-U7049BT KDC-U6049L KDC-U7049BTL [ ] [ ] [iPod] Control knob [SRC] [LOG] Registering cell-phone KDC-U6049 KDC-U6049L Register your Bluetooth cell-phone in By operating the cell-phone, register this unit. the hands-free unit (pairing). Select “KCA-BT200”...
Page 9
Calling a number in the Phone Answering a phone call KDC-U7049BT KDC-U7049BTL book Press the [ ] button. Dial the phone number in the phone book of your cell phone. KDC-U6049 KDC-U6049L If the phone book has not been Press the Control knob.
..4 sake, leave the mounting and wiring work to professionals. • If you experience problems during (KDC-U7049BT, KDC-U7049BTL only) installation, consult your Kenwood dealer. Disconnect the battery’s negative terminal ..1 (3m) and make all electrical connections before installing the unit.
Page 11
• Mount the unit so that the mounting angle is 30° or less. • Reception may drop if there are metal objects near the Bluetooth antenna. (KDC-U7049BT, KDC-U7049BTL only) Bluetooth antenna unit English | 11...
Connecting wires to terminals To Kenwood disc changer/ External optional accessory ⁄ To connect these leads, refer to the relevant instruction manuals. ⁄ • Speaker Impedance: 4 – 8 Ω • USB terminal Maximum Supply current: 500 mA White To front left speaker...
Page 13
Connect to the terminal that is grounded when either the telephone rings or during Brown (Mute control wire) conversation. (KDC-U6049, KDC-U6049L MUTE only) ⁄ To connect the Kenwood navigation system, consult your navigation Orange/ White manual. (Dimmer control wire) To car light control switch ILLUMI...
Installation/Removal of the unit Non-Japanese cars Removing the hard rubber frame Engage the catch pins on the removal tool and remove the two locks on the upper level. Lift up and pull the frame forward as shown in the figure. Catch Bend the tabs of the mounting sleeve Lock...
KDC-U7049BT, KDC-U7049BTL only Installation of the Appendix Microphone Unit About Audio file • Playable Audio file Check the installation position of the AAC-LC (.m4a), MP3 (.mp3), WMA (.wma) microphone (accessory 5). • Playable disc media Remove oil and other dirt from the CD-R/RW/ROM installation surface.
• The Bluetooth word mark and logos are This symbol mark indicates that owned by the Bluetooth SIG, Inc. and any use of such marks by Kenwood Corporation Kenwood manufactured this is under license. Other trademarks and trade product so as to decrease harmful names are those of their respective owners.
Page 32
使用激光的产品标志 (部分地区除外) ・ "Made for iPod" and "Made for iPhone" mean that an electronic accessory has CLASS 1 been designed to connect specifically to iPod or iPhone, respectively, and has LASER PRODUCT been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the 1类激光产品 use of this accessory with iPod or iPhone may affect wireless performance. ・ iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., 贴附在机架或外盒上的标记,是表示该产品使 registered in the U.S. and other countries. ・ The “AAC” logo is a trademark of Dolby 用了分类为CLASS1激光的标志,表明本装置利 Laboratories. 用了最弱级的激光束,并无向装置外辐射的危 ・ 蓝牙名称标识和徽标由Bluetooth SIG,Inc.拥 险。 有。建伍公司获得了该标识的使用许可。其 他商标和商号分别由其拥有人拥有。 本象征标志表示,建伍公司制造 的本产品有利于减少对环境的有 害影响。 产品中有毒有害物质或元素的名称及含量 有毒有害物质或元素 部件名称 铅 汞 镉 六价铬 多溴联苯...