Chapter 5. Cpe Mode Configuration; External Network Connection; Network Requirement - TRENDnet 14dBi User Manual

Chapter 5. CPE Mode Configuration

When CPE mode is chosen, the system can be configured as a Customer Premises Equipment (CPE). This
section provides detailed explanation for users to configure in the CPE mode with help of illustrations. In the
CPE mode, functions listed in the table below are also available from the Web-based GUI interface.
OPTION System
Operating Mode
WAN
LAN
Functions
DDNS Setup
Time Server
SNMP
UPNP

5.1 External Network Connection

5.1.1 Network Requirement

It can be used as an Outdoor Customer Premises Equipment (CPE) to receive wireless signal over last mile
application, helping WISPs deliver wireless broadband Internet service to residents and business customers. In
the CPE mode, TEW-455APBO is a gateway enabled with NAT and DHCP Server functions. The wired clients
connected to TEW-455APBO are in different subnet from those connected to Main Base Station, and, in CPE
mode, it does not accept wireless association from wireless clients.
Wireless
General Setup
Wireless Profile IP Filter Setup
Site Survey MAC Filter Setup
Virtual Server
Table 5-1: CPE Mode Functions
Figure 5-1 CPE mode configuration
62
TEW-455APBO High Power Wireless Outdoor PoE Access Point
Advance Utilities
DMZ Management
Profiles Settings
Firmware
Upgrade
Network Utility
Reboot
User Manual
Status
System Overview
DHCP Clients
Extra Info
Event Log