Installing Oem Drivers In The Boot Image; Creating The Boot Image - HP BL860c Administrator's Manual

SSTK only supports DHCPv6 and Router Advertisement IPv6 addresses. If you need to use the
1
IPv6 address directly, you must convert the IPv6 address to the Microsoft ipv6-literal
namespace format. Convert the colon symbol (:) to the hyphen symbol (-) and append
ipv6-literal.net . For example, convert the Router Advertisement IPv6 Address
2001:db8:100:f101:21a:4bff:fecd:8697 to
2001-db8-100-f101-21a-4bff-fecd-8697.ipv6-literal.net. For example,
convert the DHCPv6 IPv6 Address: 2002::2 to 2002--2.ipv6-literal.net.
The repository password can consist of up to 127 alphanumeric characters, including the
2
following symbols: `, ~, !, @, #, $, %, ^, &, *, (, ), _, +, -, =, {, }, |, [, ], \, :, ", ; , ',
<, >, ?, ,, and .. In addition, blank spaces are also valid. If you use any of the previous
non-alphanumeric characters or blank spaces, you must enclose the password in quotation
marks. If you use ", you must escape it with \. For example, if you enter
"myStrong385$%\"paSsWorD" in sstkencrypt, the command outputs
549eae85aba6a89e9c676a6659579356a99188a789a0a77659. Use the sstkencrypt
output to set the repository_encrypted_pass variable.

Installing OEM drivers in the boot image

Installing OEM drivers in the SSTK boot image does the following:
Guarantees that the SSTK utilities run on WinPE.
Provides hardware support during Windows Server 2008 SP2 and Windows Server R2 setup.
Appendix A (page 53)
boot image.
Any device driver placed under boot\OEMDrivers folder is automatically installed on the SSTK
boot image when it is created. For example, to add the Emulex 4Gb device driver for A8002A
and A8003A controllers, follow these steps:
1. Extract the Integrity Support Pack 7.1 package that contains the driver files.
2. Under the SSTK boot\OEMDrivers folder create a new folder with a generic name. For
example, \boot\OEMDrivers\emulex. The folder name must not contain any white spaces.
3. Copy all files extracted from the ISP component to that folder. Be sure to copy the SYS, CAT,
and INF files.
Use this procedure to add other device drivers.

Creating the boot image

To create an SSTK boot image, follow these steps:
1. Navigate to the \boot folder as follows:
cd \SSTK-WindowsIntegrity-4.1\boot\
2. Run the mkbootimg.cmd script as follows:
mkbootimg
This script creates a customized image (boot.wim) in the winpe\iso\sources\ folder. For a
description of the mkbootimg.cmd script, see
This script has the following characteristics:
Assumes that a default AIK installation is located at the following location:
%ProgramFiles%\Windows AIK\
If you want to change the location of the Windows AIK, change the SOURCE variable in the
mkbootimg.cmd script.
shows the hardware that require you to install an OEM driver in the SSTK
"Customizing the SSTK boot image" (page
Installing OEM drivers in the boot image
30).
13