HP BL860c Administrator's Manual page 10

10 Overview
ApplyHWConf
SetHBABootDevice.cmd
DeployWS2008.cmd
CheckESP.cmd
SetWS2008SP2.cmd,
SetWS2008R2.cmd
CaptureArrayConfiguration
ApplySaSConf
SSTKLogInit, SSTKLogger
Called if the configured action is
applyhwconf. It calls conrep, the
Emulex and QLogic configuration tools,
and hpacuscripting. See
"applyhwconf action" (page
Capture the Fibre Channel Controller HBA
INI file (hba_emulex.ini or
hba_qlogic.ini), updates it with
information about WWID and LUN, and
applies the new configuration in the card.
For Emulex, it also sets the
HostAdapterBiosEnable and
SelectBootEnable parameters. For
QLogic, it also sets the SelectiveLogin
parameter.
Performs Windows Server 2008 SP2 or
Windows Server R2 installation. See
"deploy action" (page
Tests if there is more than one ESP partition
on the system.
Optional scripts for configuring a deploy
action manually from the command
prompt. If you use these scripts, you do
not need to reconfigure the
SSTKConfig.cmd file. These scripts set
the os_deploy variable to
2008-server-sp2 and
2008-server-r2, respectively. The
scripts also set the paths to the answer files
(unattend_files variable) and to the
OS installation files (windows_files
variable). To run these scripts, follow these
steps:
1. At the command prompt, run
SSTKStart.cmd.
2. Run SetWS2008SP2.cmd or
SetWS2008R2.cmd (Windows
Server 2008 SP2 or Windows Server
2008 R2, respectively).
3. Run DeployWS2008.cmd to begin
the deployment process.
Runs the hpacuscripting utility to
capture the Smart Array RAID
configuration.
Applies RAID 1 configuration to an LSI
1068 controller on BL860c systems and
RAID1 + RAID1 configuration to an LSI
1068 controller on and BL870c systems.
See "applysasconf action" (page
Manages the SSTK log system. See
log file" (page 28).
20).
22).
21).
"SSTK