Press Ctrl + D within four seconds after the "Press Ctrl+D to access BASIC BOOT MENU" prompt
2.
message appears. If you fail to do this within the time limit, the system starts to run the extended
BootWare segment.
======================<BASIC-BOOTWARE MENU(Ver 1.07)>=======================
|<1> Modify Serial Interface Parameter
|<2> Update Extend BootWare
|<3> Update Full BootWare
|<4> Boot Extend BootWare
|<5> Boot Backup Extend BootWare
|<0> Reboot
============================================================================
Ctrl+U: Access BASIC-ASSISTANT MENU
Enter your choice(0-5):
Table 8 BASIC-BOOTWARE menu options
Option
<1> Modify Serial Interface Parameter
<2> Update Extend BootWare
<3> Update Full BootWare
<4> Boot Extend BootWare
<5> Boot Backup Extend BootWare
<0> Reboot
Ctrl+U: Access BASIC-ASSISTANT MENU
Modifying serial port parameters
When using the console port to access the system, make sure the port parameters are consistent with the
serial port settings on the configuration terminal, including the baudrate, data bits, parity check, stop bits,
flow control, and emulation. If the settings are inconsistent, communication will fail.
With BootWare, you can change the baudrate. HP recommends that you change the default baudrate
(9600 bps) to a higher baudrate for faster file transfer before downloading a system software image with
XMODEM through the console port.
To change the baudrate of the console port:
Enter 1 in the BASIC-BOOTWARE menu.
1.
Enter your choice(0-5): 1
===============================<BAUDRATE SET>===============================
|Note:'*'indicates the current baudrate
|
|---------------------------<Baudrate Available>---------------------------|
Change The HyperTerminal's Baudrate Accordingly
Task
Change the baudrate of the console port.
Perform this task before downloading an image through the
console port for software upgrade.
Update the extended BootWare segment.
If the corrupted extended segment has corrupted, choose this
option to repair it.
Update the entire BootWare, including the basic segment
and the extended segment.
Run the primary extended BootWare segment.
Run the backup extended BootWare segment.
Reboot the device.
Press Ctrl + U to access the BASIC-ASSISTANT menu.
21
|
|
|
|
|
|
|
|