Upgrading Bootware - HP 6125G Release Note

Figure 7 File transfer progress
When the Serial submenu appears after the file transfer is complete, enter 0 at the prompt to return
17.
to the BootWare menu.
Download successfully!
17911808 bytes downloaded!
Input the File Name:main.bin
Updating File flash:/main.bin..............................................
.....................................................Done!
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash
|<1> Download Application Program To SDRAM And Run
|<2> Update Main Application File
|<3> Modify Serial Interface Parameter
|<0> Exit To Main Menu
============================================================================
Enter your choice(0-3):
Enter 1 in the BootWare menu to boot the system.
18.
If you are using a download rate other than 9600 bps, change the baudrate of the terminal to
19.
9600 bps. If the baudrate has been set to 9600 bps, skip this step.

Upgrading BootWare

Upgrade the BootWare from the BootWare menu by using one of the following methods:
Using TFTP through the management Ethernet port

Using FTP through the management Ethernet port

Using Xmodem through the console port

46
|
|
|
|
|