HP 6125G Release Note page 55

Enter 0 in the BootWare update menu to return to the BootWare submenu.
10.
Enter 0 in the BootWare submenu to return to the BootWare menu.
11.
Enter 0 in the BootWare menu to reboot the switch with the new BootWare image.
12.
Using Xmodem through the console port
XMODEM download through the console port is slower than TFTP or FTP download through the
management Ethernet port. To save time, use the management Ethernet port as possible as you can.
Connect the console port of the switch to the PC that stores the target BootWare image.
1.
Run the terminal emulation program on the PC. Start the switch to enter the boot menu (see
2.
Accessing the BootWare menu
Enter 7 in the BootWare menu to access the Operation submenu.
3.
=========================<BootWare Operation Menu>==========================
|Note:the operating device is flash
|<1> Backup Full BootWare
|<2> Restore Full BootWare
|<3> Update BootWare By Serial
|<4> Update BootWare By Ethernet
|<0> Exit To Main Menu
============================================================================
Enter your choice(0-4):
Enter 3 in the BootWare menu to access the Serial submenu.
4.
====================<BOOTWARE OPERATION SERIAL SUB-MENU>====================
|<1> Update Full BootWare
|<2> Update Extend BootWare
|<3> Update Basic BootWare
|<4> Modify Serial Interface Parameter
|<0> Exit To Main Menu
============================================================================
Enter your choice(0-4):
Enter 4 to set the XMODEM download baudrate.
5.
===============================<BAUDRATE SET>===============================
|Note:'*'indicates the current baudrate
|
|---------------------------<Baudrate Available>---------------------------|
|<1> 9600(Default)*
|<2> 19200
|<3> 38400
|<4> 57600
|<5> 115200
|<0> Exit
============================================================================
Enter your choice(0-5):
Select an appropriate baudrate for the console port. For example, enter 5 to select 115200 bps.
6.
Baudrate has been changed to 115200 bps.
Please change the terminal's baudrate to 115200 bps, press ENTER when ready.
Change The HyperTerminal's Baudrate Accordingly
for more information).
51
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|