HP 6125G Release Note page 21

Slot 2:
The current configuration file is saved successfully.
Configuration is saved to device successfully.
Reboot the IRF fabric to complete the upgrade.
4.
<Sysname> reboot
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Reboot device by command.
Perform the display version command in any view to verify that the new version is running (details
5.
not shown).
To upgrade the system software by using the automatic software upgrade function:
NOTE:
When you add a switch to the IRF fabric, the automatic software upgrade function compares the software
versions of the switch and the IRF master. If the versions are different, the switch automatically downloads
the system software image from the master, sets the downloaded file as the system software used at the
next reboot, and automatically reboots with the new system software image to re-join the IRF fabric.
Perform the irf auto-update enable command to enable the automatic software upgrade function
1.
for the IRF fabric.
<Sysname> system-view
[Sysname] irf auto-update enable
Perform the quit command to return to user view.
2.
[Sysname] quit
Perform the bootrom command in user view to manually upgrade the BootWare image of the
3.
master.
If the system software image contains the BootWare image, this step is required. If not, skip this
step.
<Sysname> bootrom update file newest.bin slot 1
This command will update bootrom file on the specified board(s),
Continue? [Y/N]:y
Now updating bootrom, please wait...
Bootrom update succeeded in slot 1.
NOTE:
Manually upgrading the BootWare image of the master can avoid the following problem. During the
reboot process, the master automatically upgrades the BootWare image and thus gets delayed. As a
result, the master re-joins the IRF as a subordinate and the subordinate becomes the new master. The
subordinate and master have different image versions, so the subordinate automatically downloads the
old system software image from the new master, and automatically reboots with the old system software
image. The upgrade fails.
Perform the boot-loader command in user view to load the file newest.bin and specify the file as
4.
the main image file at the next reboot.
<Sysname> boot-loader file newest.bin slot 1 main
17