Sensors And Zones - GE 45129 User Manual

Step 1 -
A. Press and hold the Learn button (unit will beep).
B. While continuing to press the Learn button,
press and hold Arm button (within three seconds).
C. When Control Center sounds a long beep, release
buttons. The green LED power indicator will begin
flashingThis indicates the unit is ready to change the
Security Code.
Step 2 - While the LED indicator is flashing, enter the
current Security Code (if new, then enter the factory
Security Code of '1 2 3 4'.)
Step 3 - Enter your new four digit Code.
Step 4 -
A. Enter your new four digit Code again
to confirm.
B. A long 'beep' will sound and the green LED
indicator will stop flashing. Your new Code has
been set.
Note:
- If the Security Code is lost or forgotten, you can restore the
Control Center back to factory default Security Code setting
('1 2 3 4'). Remove the batteries and AC adapter. Press
and hold the Learn button and plug the AC adapter
back in (continue pressing the Learn button). Wait until
all 4 Zone LED indicators are on and the Zone 1 LED indicator
begins to flash. The Control Center will need four hours to
reset the Security Code back to the factory Default '1 2 3 4'.
Once all Zone LED indicators turn off, the system will be
reset to the factory default. The alarm system
cannot be used during this four hour reset process.

Sensors and Zones

There are four Zones, and each Zone can hold up to
four Sensors - Any combination of Sensors (Motion,
Door, Water or Garage) can be assigned to any of the
four Zones. If you decide to expand, it is important
to know you can always add more Sensors, (16 total).
Zones ,  and  are designated for Arm/Alarm,
or Notification modes.
Mode settings
1 2 3 4
1 2 3 4
Zone
Zone 4 is designated for detected Alerts only. Use
Zone 4 for areas you wish to continuously monitor,
but don't want to trigger the alarm (e.g. notification
of water leaks, garage door is up, back gate left
Zone 4
1 2 3 4
1 2 3 4
Zone

Control Center has
Input DC 12V
three Mode settings
-
+
Mute
"Alert" - Continuous Tone
"Chime" - Single Tone
Learn
"Off" - Lights only
Arm
Alert Notification switch
Chime
(affects Zone 1, 2, 3 only)
Off
Armed Power
Continuosly Monitors
any area, in and around
the home, using any
combination of the
Input DC 12V
- four Sensors
+
Mute
Learn
Note: Zone 4 is not
Arm
affected by Notification
Alert
mode switch, and does
Chime
Off not activate alarm
Armed Power
Deticated Alert
Zone (Zone 4)