Arming The System (Home Or Away); Disarming The System - GE 45129 User Manual

Arm (HOME) – No delay, instant alarm.
This setting is used when you wish to secure the area
but will be home and moving around within the armed
area. In the Arm/HOME setting, any Motion Sensors in
Zone 1, 2, and 3 will not operate. All Sensors must be
closed/not activated in order to set the alarm.
To set the system in HOME mode
HOME Mode
1 2 3 4
1 2 3 4
Zone
Only Zones 1, 2, and 3
Step 1 - Enter your four digit Security Code.
Step 2 - Press/hold the Arm button
for two seconds. The red Arm LED indicator
will turn on. The system is now Armed.
Arm (AWAY) – Delayed alarm for entry/exit.
After the system is armed a 45 second delay begins.
This is to allow time to leave the protected area before
system is active. The Control Center will begin beeping
and the Armed LED indicator will begin to flash. During
the last 10 seconds the beeping will speed up indicating
the alarm will arm shortly. Once the alarm has become
active, the red LED indicator will continue to flash
To set the Alarm in Home Mode
tep 1
S
Enter four digit Security Code
Step 2
Press and HOLD "Arm "
button for two seconds
Input DC 12V
-
+
Note: Motion Sensors do not
Mute
operate in HOME Mode.
Learn
The Armed LED indicator
Arm
turns on
Alert
Chime
Step 3
Off
Armed Power
To disarm, enter the four
digit Security Code
until system is disarmed. In the Arm/AWAY setting,
all Sensors in Zones 1, 2, and 3 will trigger the Alarm
System. All Sensors must be closed/not activated in
order to set alarm.
To set system in AWAY mode
Step 1 - Enter your four digit Security Code.
Step 2 - Press the Arm button two times. The red
alarm LED indicator will flash continuously.
AWAY Mode
1 2 3 4
1 2 3 4
Zone
Only Zones 1, 2, and 3
Note: If a Sensor is triggered in Zone 4 it will not activate the
alarm. It will sound an alert tone only. (See Zone 4 page 9)'.

Disarming the System

When you return to the protected area the unit will
trigger and give you 30 seconds to disarm the system.
To disarm the system at any time, enter the four digit
Security Code. Entering the four digit Security Code will
disarm the system during the 30 second delay entry
period, or even if the alarm has been triggered and the
siren is sounding.

To set the Alarm in Away Mode
Step 1
Enter four digit Security Code
Step 2
Press "Arm " button twice
Input DC 12V
-
+
Mute
The Armed LED indicator
Learn begins flashing
(45 seconds to exit)
Arm
Alert
Step 3
Chime
Armed Power Off To disarm, enter the four
digit Security Code
30 seconds to enter)